Our commercial roof repair services in Harrisburg cover flat, metal, leak, and industrial roof work, each started by finding where water actually enters.
Each of our commercial roof repair services in Harrisburg answers a different kind of roof failure. Pick the row that matches your building, or call if two rows seem to fit.
Single-ply, built-up, and modified roofs on low-slope buildings. Repairs cover drains, laps, blisters, and wet board, with patches reaching dry membrane on every side. Ponding is fixed at its cause, whether a clogged outlet or crushed insulation.
Exposed-fastener and standing-seam panels on shops and storage buildings, with repairs aimed at the attachment instead of surface sealant. Rusted panels are swapped for the same rib profile and lapped into firm metal.
For drips with no obvious source, tracing runs from the interior stain across the deck to the seam, curb, drain, or wall that let water in. Interior access is planned with your staff before any ceiling tile comes down.
Roofs over production, processing, and food storage, where fans, stacks, and lockout planning shape every repair visit. Exhaust residue is cleaned or cut out before new flashing goes on.
The same leak looks different on each roof system. These columns compare what fails first, how it gets fixed, and where a repair stops.
Describe the building, the roof system if you know it, and where water shows up. The inspection decides the repair type, and you get the findings in writing. Photos of the stain help us prepare.
Whatever the roof system, each visit follows the same four steps, and you see the findings before any wider work is discussed.
We start with where water shows, when it started, the roof system if known, and how to reach the roof. Photos from staff and any earlier repair notes help us plan the first walk.
Seams, drains, curbs, edges, and flashing around the reported area are checked, with core cuts where moisture is suspected. The walk widens until the water path makes sense.
Damaged material is cut back to dry, solid roof on every side, and the new detail is tied in there. Wet insulation inside the boundary is replaced, never covered over.
Photos, core results, and notes on any wider concerns come to you after the repair. Repaired details are marked on a simple roof plan for the next visit.
Answers on weather, storms, codes, and how each roof repair job is scoped and priced.
Access changes first. Heavy wet snow can raise questions about the roof structure, so visible sagging or distress calls for a structural evaluation before anyone works up there. Interior protection and clear leak reports continue while the repair waits for safe access. Once the snow is gone, drains and seams along the meltwater path are checked first.
We compare wet patterns, timing, and what the roof shows. Hail marks, wind-lifted flashing, and condensation each leave different evidence. In older brick buildings the walls and roof-to-wall joints get checked too, because water can arrive by more than one route. Timing helps most: a stain that grows on humid days without rain points away from the roof.
The affected area, the known roof layers, and any planned insulation or deck replacement. Some details stay open until damaged material is cut out. Pennsylvania's Uniform Construction Code sets the statewide framework, and the reviewing authority decides what applies to the actual project. We describe the scope in writing so that office has what it needs.
The reviewing authority for the property decides whether deck or insulation replacement needs review. We describe the scope clearly so the owner can ask the right office before work starts. Repairs that only replace flashing or seams are usually simpler to describe.
By the inspection. The roof system, the number of damaged areas, core-cut results, flashing and drain work, and access all feed the written scope, which states whether a local repair or a section rebuild fits. Any concern beyond the repair, such as an aging membrane elsewhere, is listed separately.
Yes. A warehouse with a metal shop addition can need flat roof patches and fastener work on the same trip, and both go into one set of findings. Grouping them saves a second trip up the ladder and a second set of protection inside.
Tell us the building and where the roof leaks. We inspect it, recommend the repair type in writing, and price the work before it starts.
